
	Already a member? Login here. If not, Register Today! \| Help

Newest | Active | Popular | RVing FAQ

Forum Rules | Forum Help and Support | Contact

Open Roads Forum > Dinghy Towing

This Topic Is Closed | Print Topic | Post New Topic |

Sponsored By:

TimLoon

With the 4 Granddaughers in CT

Senior Member

Joined: 07/21/2003

View Profile

Good Sam RV Club Member

Posted: 04/07/12 06:45pm

Link | Print | Notify Moderator

On my 2005 CRV, I installed the Blue Ox light system by drilling the tail lenses and installing the 2 filament bulbs which run off a 4 wire trailer harness. That and the base plate installation went fine but now I am a bit perplexed by the wiring. The MH has a 7 way plug that I stepped down to a 6 way adaptor and ran a 6 pin wire to the Toad. I am using the 12 V pin for charging but can't figure out how to wire turn signals, lights and brakes without using the 3 to 2 converter. Am I mssing something? Thanks, Tim

2007 Chevy Extended Cab, 4wd,6.0,
2008 Cougar 26RLS X-LITE

Ivylog

Blairsville, Ga. USA

Senior Member

Joined: 06/30/2004

View Profile

Offline

Posted: 04/07/12 07:24pm

Link | Print | Notify Moderator

These plugs are color coded so it should be a simple matter of matching colors. Use this guide for the colors.

This post is my opinion (free advice). It is not intended to influence anyone's judgment nor do I advocate anyone do what I propose.

04 Monaco Dynasty 42' quad slide
Where am I?
How I tow.