My 2010 Cyclone 3010 has two switchs for the Electric hot water heater. The first inside, looks like a normal wall switch and yes it lights up. The second is a toggle switch with a pin to hold it in the OFF position in the water heater outside compartment. BOTH have to be ON with 110 V hook ups for it to work. I had a dealer in Alaska show me this works because I could not get it to work, and it is not in any the books. Once turned on it works good. And, Yes it is very easy to fry the element, must have water at all times or it is gone in seconds.
I have a '10 Cyclone 3912. I checked the continuity of element. OK
Switch is on in heater bay.
110-volt illuminated switch on panel inside lights up...so I assume it is getting power. No shore power today, so didn't check at element for 110 volts. No hot water. Any ideas??? Thanks in advance.