My parts came today. $400 and change for the transfer case half, billet pump, magnetic plug, output shaft seal, gasket, breather tube, and a tube of RTV. For the record I did NOT have the pump rub through the case, I cracked it myself. Don't ask. But I would like to tar and feather the moron at New Process who decided it was a good idea to make the housing out of magnesium and then put in a PIPE THREAD for the drain plug. And don't always believe those torque values. The new case is aluminum.
If ya'll are in the neighborhood stop on by and lend a hand.
Mike
Bubba,
Good luck!
May all the proper tools make themselves easily visible, and not slip when used. Give them a pep talk before starting. Works for me. ha
I grew up in Mich, If I still lived there I would come. GA is too far for a weekend.
Kurt
2001 Silverado 3500 DRW CC LB 6.0
1993 Lance Squire Lite 150 (8'6")
2001 Fleetwood Caribou 11J (11'6")
Offline
Don't ask. But I would like to tar and feather the moron at New Process who decided it was a good idea to make the housing out of magnesium and then put in a PIPE THREAD for the drain plug.
And don't always believe those torque values. The new case is aluminum.
