| |
Subject |
Author |
Date Posted |
Forum
|
 |
RE: can't get auto level control to come on?
Found the problem. And it took a voltage meter. The fuse in the front storage bin on the wire from the battery to the control module was only allowing 11 volts of juice. The fuse was lit up and showed continuity.
Also Lippert says the wire from the control panel should be connected directly to the battery not to the block near the battery.
I did that and put a new fuse in and it all works. 2 volts low and it would not work. Hope this helps someone else in the future.
|
fowlthing
|
09/08/21 07:38pm |
Tech Issues
|
|
RE: can't get auto level control to come on?
I have ordered the control module that is in the front storage compartment.. maybe it will do the trick
FYI figured out that after opening the valve for the front legs... we could hit a slide out button and the front legs would raise and level.. little easier than the impact wrench in side the storage compartment.
|
fowlthing
|
09/06/21 06:28pm |
Tech Issues
|
|
RE: can't get auto level control to come on?
Replaced the Lippert panel. More lights come on. But. The LCD does not.
Any suggestions are welcome.
|
fowlthing
|
09/05/21 11:31am |
Tech Issues
|
|
RE: can't get auto level control to come on?
Manual override of the hydraulic jacks wasn’t very difficult. Used impact wrench and Allen wrench.
Going to buy a new control panel and see if that solves the issue.
|
fowlthing
|
09/03/21 07:49am |
Tech Issues
|
|
RE: can't get auto level control to come on?
Thanks. I am too tired to do anything else tonight. I sent a chat message to Lippert earlier. But no response. Yet.
|
fowlthing
|
09/02/21 10:12pm |
Tech Issues
|
|
RE: can't get auto level control to come on?
no parking brake on the fifth wheel..
I unplugged the control unit and reconnected and got these lights to come on
but that is it
https://i.imgur.com/3Ed2AWIl.jpg
|
fowlthing
|
09/02/21 08:48pm |
Tech Issues
|
|
can't get auto level control to come on?
Grand design 2019 37res
fuses all test good. Found one fuse in the front storage bin. it is good
Put new battery on. Have 12v power to lights.
disconnected shore power and battery hoping for reset.
Nothing.
Any help is welcome. Trying to leave town.
Thanks
|
fowlthing
|
09/02/21 07:30pm |
Tech Issues
|
|
RE: Can't get these specific lights on ? Switch is a mystery?
Well, got all the lights working. Still don't know what the switch is for... will use the tester to see if I can get that figured out.
The light issue was really simple... turns out the switch for lights by the microwave is under the cabinet. And the other set of lights are controlled by a smaller red switch. But very obvious and labeled. Not so proud of this moment.
Thanks for the input. I learned about the tester and about the switch under the cabinet. Which should not have been a question since so many other lights are controlled by switches in similar places.
My apologies for not spending more time before posting.
|
fowlthing
|
08/14/21 08:04pm |
Tech Issues
|
|
RE: Can't get these specific lights on ? Switch is a mystery?
I will get the tracker.... would be good for many things... thanks
|
fowlthing
|
08/12/21 08:39am |
Tech Issues
|
|
Can't get these specific lights on ? Switch is a mystery?
We have four lights in our Grand Design Solitude 375res that we can't get to come on. Fuses are good. Two are above the microwave and two above the hutch.
This switch I can't figure out what it goes too?
The switch is under the hutch?
https://i.imgur.com/zP3jOEVl.jpg
https://i.imgur.com/tRA3Fpcl.jpg
https://i.imgur.com/JppVrsKl.jpg
https://i.imgur.com/SiWoe3Yl.jpg
|
fowlthing
|
08/11/21 01:51pm |
Tech Issues
|
|
RE: Condensation pan is not draining?
Found the issue...removed outside cover and the hose was clogged there...posted before I had investigated enough...
|
fowlthing
|
06/12/21 12:22pm |
Tech Issues
|
|
Condensation pan is not draining?
Have 2019 Solitude 375res It appears the drain hose from the refrigerator condensation pan is clogged. I have blown on the drain and put a wire down it to attempt unclogging.
By chance is there a valve that needs opened under the camper?
Any suggestions or advice is welcome.
Thanks
|
fowlthing
|
06/12/21 11:39am |
Tech Issues
|
|
RE: slide out leaks when pulled in??
Yes I believe the water is only coming in after slides are in... and water is coming in underneath the slide.
I will need to really watch and see if it is after fully retracted or maybe as we slide in water is dragged inside.
Great point... thanks for the insight.
|
fowlthing
|
05/31/21 05:49pm |
Tech Issues
|
|
slide out leaks when pulled in??
Things to look for? I am convinced they are fully closing...
The horizonal seal seems to me to allow water to build up and go back into the camper?
Thanks for any help
Grant
|
fowlthing
|
05/31/21 01:42pm |
Tech Issues
|
|
RE: lippert auto level will not come on?
It was the inline 10A fuse... thanks so much
|
fowlthing
|
05/27/21 06:57am |
Tech Issues
|
|
lippert auto level will not come on?
I have grand design 2019 375res. I have power everywhere else.. and all fuses and breakers look good.
Surely there is something I am missing??
Trying to leave town.. any help is welcome.
Grant
|
fowlthing
|
05/26/21 05:28pm |
Tech Issues
|
|
RE: Air ride suspension or not?
SRW
|
fowlthing
|
02/09/21 12:12pm |
Tow Vehicles
|
|
Air ride suspension or not?
I currently have a F350 towing a Solitude 375RES. and don't have air ride suspension.
Looking at a new Ram 3500 do I get it or not? What do you like about your air ride ?
|
fowlthing
|
02/09/21 08:38am |
Tow Vehicles
|
 |
Air ride suspension or not?
I currently have a F350 towing a Solitude 375RES. and don't have air ride suspension.
Looking at a new Ram 3500 do I get it or not? What do you like about your air ride ?
|
fowlthing
|
02/09/21 08:13am |
Fifth-Wheels
|
|
RE: Mega Cam Ram 3500 and towing fifth wheel
Will have to check..Truck is in the shop now..I assume the gooseneck ball is over the axel.. that measured 31 best I can remember inches on both the ram and the ford
|
fowlthing
|
02/07/21 02:02pm |
Fifth-Wheels
|
